How To Assemble A Queen Size Sleep Number Bed

How to Assemble a Queen Size Sleep Number Bed

Sleep Number beds, known for their adjustable firmness and personalized comfort, require a bit more assembly than traditional mattresses. The process, however, is straightforward and can be completed with minimal tools and effort. This article will guide you through the steps of assembling a queen size Sleep Number bed, ensuring a smooth and successful setup.

1. Unpacking and Preparing

Before you begin assembly, ensure you have a clear and spacious area to work with. Gather the following tools:

Phillips head screwdriver
Adjustable wrench (optional)
Level (optional)

Carefully unpack the bed components. The contents typically include:

Two bed frames
Two comfort layers (air chambers)
Two base layers (foundation)
Headboard and footboard (if applicable)
Hardware (screws, nuts, washers)
Instruction manual

It is essential to refer to the instruction manual for specific guidance on your model. Each Sleep Number bed may have slight variations in components or assembly steps.

2. Assembling the Frames

Start by connecting the two bed frames. The frames usually consist of a headboard, footboard, and side rails that interlock. Follow these steps:

Lay one frame on its side with the headboard facing up. Align the side rails and headboard with the corresponding slots or holes.
Insert the provided hardware (screws, nuts, or bolts) into the designated locations. Tighten the screws with a Phillips head screwdriver, ensuring a secure connection.
Repeat the process for the other side of the frame. Ensure that both sides are aligned and securely fastened.
Once both frames are assembled, place them side-by-side, aligning the headboards together.
Connect the two frames by sliding them together. The frames should have connecting points with corresponding slots or holes.
Secure the connection with the provided hardware, making sure both frames are firmly joined.

If your bed includes a footboard, attach it in a similar manner using the included hardware.

3. Installing the Comfort and Base Layers

The next step is to install the comfort layers (air chambers) and base layers. The installation process may vary slightly depending on your Sleep Number model. However, the general steps remain the same:

Place one base layer on top of each frame, ensuring the fabric side faces upwards.
Align the base layers with the bed frame, making sure they are centered and flush with the edges.
Secure the base layers to the frames using the provided clips or straps. Refer to the instruction manual for specific guidance on securing the base layers.
Next, position the comfort layers on top of the base layers, ensuring the air valves are facing the foot of the bed.
Attach the comfort layers to the base layers. Some models may have built-in mechanisms to secure the layers, while others may require straps or clips.
Connect the air valves of the comfort layers to the control unit or pump. Ensure the connections are secure and airtight.

The control unit or pump is used to adjust the firmness of each side of the bed according to your preferences.

4. Final Adjustments and Testing

Once the bed is assembled, you can proceed with final adjustments and testing. Use the control unit or pump to adjust the firmness levels on each side of the bed to your desired comfort.

After adjusting the firmness, make sure the bed is level. Use a level tool to ensure that the bed is not tilted or uneven. You can adjust the legs or feet of the bed if necessary. Finally, test the comfort and functionality of the bed by lying on it and adjusting the firmness levels to your preference.

Remember to always refer to the instruction manual for specific guidance on your model. If you encounter any difficulties during the assembly process, consult the manual or contact Sleep Number customer support for assistance.